[Systems Engineering Teachers' Mailing List] 3D printers

[ten Seldam, Christopher C]

Hi, I am considering buying a 3D printer to use with my Systems classes.

Does anyone have any experience with purchasing an appropriate printer in the $1-2000 range for use in schools? I would prefer to buy from an Australian supplier that may be able to provide reasonable support when required too.

Thanks for any ideas,

Regards, Chris ten Seldam.

Important - This email and any attachments may be confidential. If received in error, please contact us and delete all copies. Before opening or using attachments check them for viruses and defects. Regardless of any loss, damage or consequence, whether caused by the negligence of the sender or not, resulting directly or indirectly from the use of any attached files our liability is limited to resupplying any affected attachments. Any representations or opinions expressed are those of the individual sender, and not necessarily those of the Department of Education and Early Childhood Development.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.edulists.com.au/pipermail/syseng/attachments/20130515/073d0da1/attachment.html